Resumo Ensaios Não Destrutivos (END) são amplamente utilizados na indústria. Dentre as principais técnicas de END, as mais utilizadas são baseadas no uso do ultrassom. Uma destas técnicas é o Tempo de Voo da Onda Difratada (ToFD). A técnica ToFD baseia-se no uso de duas sondas angulares colocadas paralelamente sobre a mesma superfície, a uma distância fixa uma da outra, conhecida como Probe Center Separation (PCS). O PCS visa obter o foco das ondas sônicas em uma região específica da peça inspecionada, no entanto, o feixe não atinge totalmente a peça. Com a variação do PCS, a peça poderá ser inspecionada por completo. Portanto, foi testado se, por meio da variação do PCS, é possível minimizar a zona morta, aumentando a confiabilidade da inspeção. Concluiu-se que a variação do PCS tem influência direta sobre a identificação das descontinuidades próximas a superfície ou próximas ao fundo do bloco. Evidenciou que, para descontinuidades superficiais, o PCS menor é mais eficaz, enquanto que para descontinuidades próximas ao fundo do bloco, PCS maiores são mais eficazes. Aspectos metrológicos foram considerados neste trabalho de desenvolvimento tecnológico.
Abstract The Non-Destructive Testing (NDT) are widely used in industry. Among the main NDT techniques, the most used are based on the use of ultrasound. One of these is the Time of Flight Diffraction Technique (ToFD). The ToFD is based on the use of two angle transducers placed in parallel on the same surface at a fixed distance from one another, known as Probe Center Separation (PCS). The PCS seeks the focus of sonic waves in a part of the inspected point on which to characterize, however, the beam is not totally reaches the workpiece to be inspected. Therefore, it is believed that with the variation of PCS, the piece may be completely inspected. Therefore, it was tested whether, by varying the PCS is possible to minimize the dead zone, increasing the reliability of inspection. It was concluded that the variation of PCS in ToFD technique has direct influence in the identification of discontinuities near the surface or near the bottom of the piece. It was evident that for surface discontinuities the lowest PCS is more effective, whereas for discontinuities near the bottom, larger PCS are most efficient. Metrology is the base of this research of technological development.